How To
Simple, step-by-step video guides showing how to safely use our jump starters and the My Garage Hero Tyre Repair Kit.
The videos cover real-world situations such as flat batteries, slow leaks, and punctures. Everything is explained clearly and without jargon so you can follow along with confidence on the road.
Boost N Inflate
Boost N Inflate Pro
Tyre Repair Kit
Jump Start Instructions:
Connect the jump cables to the Boost N’ Inflate.
Attach the red clamp to your battery’s positive (+) terminal.
Attach the black clamp to the negative (–) terminal.
Wait for the light to turn solid green — this means it’s ready.
Start your engine.
Once running, disconnect the clamps (keep the engine running).
Tyre inflation Instructions:
Connect the air hose to the Boost N’ Inflate.
Attach the hose to your tyre’s valve stem and press down the tab.
Power on the device.
Use the + / – buttons to set your desired PSI.
Press the start button — inflation will begin.
The pump will automatically stop once the target PSI is reached.
Jump Start Instructions:
Connect the jump cables to the Boost N’ Inflate Pro.
Attach the red clamp to your battery’s positive (+) terminal.
Attach the black clamp to the negative (–) terminal.
Wait for the light to turn solid green — this means it’s ready.
Start your engine.
Once running, disconnect the clamps (keep the engine running).
Tyre inflation Instructions:
Connect the air hose to the Boost N’ Inflate Pro.
Attach the hose to your tyre’s valve stem and press down the tab.
Power on the device.
Use the + / – buttons to set your desired PSI.
Press the start button - inflation will begin.
The pump will automatically stop once the target PSI is reached.
Tyre Repair Kit Instructions:
Identify the puncture
Remove embedded object
Clean puncture hole with the spiral T-handle tool then leave it inserted in the puncture hole
Thread rubber strip through the needle to the T-handle insert tool
Remove spiral T-Handle tool and insert the T-handle insert tool
Once pushed in all the way, slowly remove the T-handle insert tool and twist. Cut the rubber excess.
How to Use My Garage Hero Products
Clear instructions and videos showing you how to use your jump starter, tyre inflator, and tyre repair kit the right way.
Attach the air hose securely to your tyre valve, then set your target PSI using the digital screen. Press start and the Boost N’ Inflate will automatically inflate the tyre and stop when it reaches the correct pressure. If you’re unsure what PSI to use, check the sticker inside your driver-side door.
Connect the jumper leads to the Pro unit, then attach the red clamp to the positive (+) terminal and the black clamp to the negative (–). Power on the device, wait for the ready signal, and start your engine. Once your engine starts, remove the clamps carefully in the reverse order and store the unit safely.
Screw the inflation hose onto your tyre valve, select your desired PSI on the Pro’s display, and press start. The compressor will automatically shut off once the tyre reaches the set pressure. Always replace the valve cap afterwards to keep dirt and moisture out.
First, remove the object causing the puncture. Use the spiral probe tool to clean and prepare the hole. Thread a repair plug through the insertion tool, then push it firmly into the tyre until only a small section remains visible. Pull the tool out, trim the excess plug, reinflate the tyre, and check pressure. This repair is designed for tubeless tyres and should be followed up with a professional inspection.
Attach the air hose securely to your tyre valve, then set your target PSI using the digital screen. Press start and the Boost N’ Inflate will automatically inflate the tyre and stop when it reaches the correct pressure. If you’re unsure what PSI to use, check the sticker inside your driver-side door.